Ball Tee for 1 inch O.D. Tubing, Polished Brass (00-704/1)
Our ball fittings are used to construct handrails, footrails, stair rails, bar rails, ballet rails, and many other metal railing systems. The vertical posts of the railings should be made with a continuous architectural metal tube (for strength) while the horizontals are cut and fit with architectural hardware between posts. Ball fittings may be available in a variety of finishes not usually found in traditional brass fitting, including stainless steel, and more.
All ball fittings are supplied with self-drilling, self-tapping hardware.
Material:
- Polished Brass
Dimensions:
- D: 2"
- L: 2-3/16"
Estimated Lead Time: 3-5 Business Days before shipment.
Where a branch rail meets a straight run on a 1" OD brass line, the Ball Tee makes the junction: a straight pass-through, a perpendicular outlet, and a decorative cast ball marking the joint — one fitting, cleanly resolved. Finished in polished brass for traditional interiors, fixtures, and display rails.
Description
Where a straight rail continues through a point and a branch ties in at a right angle, the Ball Tee joins all three 1" OD tubes in one cast piece — a pass-through axis, a perpendicular outlet, and a decorative ball at the joint. It's the mid-run connector for a stair rail with a landing branch or a bar rail with a return. The three tube ends seat inside the ball, so you cut the straight lengths and let the fitting hold the branch angle. Cast in polished brass for traditional and restoration rails, it pairs with the matching elbows, crosses, and single-outlet fittings in the same 1" ball line.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
