Ball Ell Brass for 1.5" O.D. Tubing (00-702/1H)
Our ball fittings are used to construct handrails, footrails, stair rails, bar rails, ballet rails, and many other metal railing systems. The vertical posts of the railings should be made with a continuous architectural metal tube (for strength) while the horizontals are cut and fit with architectural hardware between posts. Ball fittings may be available in a variety of finishes not usually found in traditional brass fitting, including stainless steel, and more.
All ball fittings are supplied with self-drilling, self-tapping hardware.
Material:
- Polished Brass
Dimensions:
- D: 2-1/2"
- L: 2-11/16"
Estimated Lead time: 3-5 business days before shipment.
Because both tube ends seat inside the ball, this 90° corner forgives imperfect cuts — the fitting conceals the tolerance entirely. The Ball El turns a 1.5" OD handrail with a decorative sphere at the joint. In polished brass, polished 304 stainless, or satin 304 stainless to match the rest of the run.
Description
A decorative cast ball marks every change of direction in this line, and the 1.5" Ball El puts one at the 90° corner: two tube ends join inside a single fitting at the head of a stair, the corner of a landing, or a balcony or deck rail — no welded corner required. Because the tube ends seat inside the ball, the straight runs are cut to length and the fitting holds the corner. Finishes: polished brass for a warm traditional rail, polished 304 stainless for a bright modern look, or satin 304 stainless for a softer, low-glare surface. Matching tees, crosses, and single-outlet fittings complete the 1.5" ball line.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
