135 degree Flush Elbow for 1.5 inch O.D. Tubing, Brass (00-730/1H)
Materials/Finishes:
- Polished Brass
Compatible Tubing Wall Thickness:
- .050"
Tubing OD:
- 1.5"
Estimated Lead time: 3-5 business days before shipment.
Landings with chamfered corners and octagonal stair geometry turn at 135°, not 90° — this flush elbow matches them. It joins 1.5" OD handrail through the wider interior angle with no fitting protruding. Five finishes: polished brass, 304 polished or satin, and 316 polished or satin stainless for coastal, pool, and food-service spots.
Description
Where a handrail bends at a wide 135° interior angle rather than a sharp corner, this flush elbow makes the turn clean. Slip a 1.5" OD tube into each end and the joint sits flush — no protruding fitting to catch a hand. It suits the shallow turns you find at four-step landings, chamfered landing corners, octagonal stairs, and angled guardrail intersections, on one flight or a full run. Pick the finish for the setting: polished brass for a warm traditional rail, 304 stainless polished or satin for a bright or low-glare modern look, or 316 stainless polished or satin where salt, chlorine, or wash-down is a factor — near the coast, at a pool, or in a food-prep area. It fits.050" wall tubing and pairs with the matching 1.5" flush fittings so a whole rail goes together from one line.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
