Ball 135 degree Side Outlet Ell Brass for 2" O.D. Tubing (00-708/2)
Our ball fittings are used to construct handrails, footrails, stair rails, bar rails, ballet rails, and many other metal railing systems. The vertical posts of the railings should be made with a continuous architectural metal tube (for strength) while the horizontals are cut and fit with architectural hardware between posts. Ball fittings may be available in a variety of finishes not usually found in traditional brass fitting, including stainless steel, and more.
All ball fittings are supplied with self-drilling, self-tapping hardware
Material:
- Polished Brass
Dimensions:
- D: 5"
- L: 3-1/4"
Estimated Lead time: 3-5 business days before shipment.
Where a heavier brass rail opens to a 135° turn and a branch has to leave from the same point, this three-outlet ball fitting carries both. The 2" OD tubes seat into one cast joint — wide turn plus perpendicular outlet, no stacked fittings. A polished brass finish completes the traditional look.
Description
At the 2" OD size, the Ball 135° Side Outlet El covers the landing that bends wide and branches at the same point: the rail turns 135° while a third outlet takes a perpendicular post or secondary rail. The three tube ends seat inside the cast ball, which holds the angles — the straight runs are simply cut to length, with no exact corner measuring. It works alongside the matching 135° and 90° ball fittings in the same 2" line, keeping an angled run visually consistent. Cast in polished brass for traditional and restoration rails.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
